XLERATOR Hand Dry
 |
• Dries hands completely in 10-15 seconds
• GreenSpec® Approved
• Uses 80% Less Energy
• 95% Cost Savings vs. Paper Towels
• Source Reduction Alternative
• Promotes Hygiene |
|
|
| GreenSpec® approved and helps contributes towards LEED credits, the XLERATOR Hand Dryer completely dries hands in 10 to 15 seconds. Sustainable Supply has the lowest wholesale distributor prices on the internet for Xlerator hand dryers..guaranteed! FREE SHIPPING ON ALL XLERATOR DRYERS. Excel Xlerator hand dryers are endorsed by the Green Hotels and Green Restaurant Associations and are used in green buildings, schools, airports, stadiums, or any other high traffic restroom. By eliminating residual moisture, the hands are warm and comfortable after drying. This new energy efficient hand dryer technology rapidly dries hands in two sequential phases. In the first phase, loose water droplets are blown from the hands with a strong, controlled air blast. In the second phase, residual moisture is evaporated and the hands are warmed by an air stream heated up to 135 degrees F (55 degrees C). |
 XLERATOR® Green Certifications pdf |
| Excel Dryers spec sheet pdf |
|
|
 |
|
|
SPECIFICATIONS:
Dimensions: 11 3/4" LG. X 12 11/16" HIGH X 6 11/16" DEEP
Weight: 16 LBS. (7.3 KGS.)
Construction
A.
Cover shall be a one-piece, heavy-duty, rib-reinforced, die-cast zinc
alloy or fiberglass re-enforced bulk molding compound (see product descriptions). It shall be lightweight, unbreakable, rustproof and all exposed
surfaces shall be bright chrome plated or finished with chip-proof,
electrostatically applied epoxy paint and fastened to a wall plate by
two chrome plated tamper-proof bolts.
B. Wall plate shall be
equipped with (3) 7/8" (22 mm) diameter holes, one of which shall be
suitable for use with surface conduit, for ease of wiring.
C. All internal parts shall be coated according to Underwriters' Laboratories, Inc. requirements.
D. Entire mechanism shall be internally grounded
Mechanism
A.
Motor shall be a series commutated through-flow discharge vacuum
motor/blower (5/8 HP / 20,000 RPM) which provides air velocity of
16,000 LFM (linear feet per minute) at the air outlet and 14,000 LFM at
the hands (4 inches [102 mm] below air outlet).
B. Heating
element (900 W) is constructed of Nichrome wire and mounted inside the
blower housing, thereby being vandal proof. It shall be protected by an
automatic resetting thermostat, which shall open whenever air flow is
cut off and shall close when flow of air is resumed. It shall produce
an air temperature of up to 135°F (57°C) at a 72°F (22°C) ambient room
temperature at the hands (4 inches [102 mm] below air outlet).
C.
Control assembly is activated by an infrared optical sensor located
next to the air outlet. The dryer shall operate as long as hands are
under the air outlet. There is a 35-second lockout feature if hands are
not removed.
Limited Warranty
The
dryer shall be guaranteed to be free from defects for a period of three
(3) years. Warranty shall include factory performed labor as well as
the repair or exchange of defective parts, at manufacturer's option.
UNITS ARE AVAILABLE AS SPECIFIED IN: 110/120 Volt, 12.5 Amps, 60HZ
|
|
|
