Shopping Cart
Save 5% Sitewide Today! Free Shipping on Qualified Orders Over $75

  Home > Building Materials > Hand Dryers >

  Xlerator XL-BW High Efficiency Hand Dryer, GreenSpec, 110V
Xlerator XL-BW High Efficiency Hand Dryer, GreenSpec, 110V


 
Brand: Xlerator
Model #: XL-BW

List Price: $620.00
Our Price: $400.00
You save $220.00!

Weight (LBS): 16
Made In: USA
Manufacturer: Xlerator
Mfg Part #: XL-BW


Availability: Usually Ships in 1 Week
Product Code: XL-BW
Qty:

Description Technical Specs Green/Sustainability Information
 
GreenSpec approved and helps contributes towards LEED credits, the XLERATOR Hand Dryer completely dries hands in 10 to 15 seconds. Endorsed by the Green Hotels and Green Restaurant Association. By eliminating residual moisture, the hands are warm and comfortable after drying. This new technology rapidly dries hands in two sequential phases. In the first phase, loose water droplets are blown from the hands with a strong, controlled air blast. In the second phase, residual moisture is evaporated and the hands are warmed by an air stream heated up to 135 degrees F (55 degrees C).

Not only does the XLERATOR® Hand Dryer dry hands in one third the time required by conventional dyers, the unit runs on 15 amp service. The combination of these two factors results in an 80 percent energy savings compared to conventional hand dryer use.

Product Details

Check out this Xlerator Video with Terry Bradshaw!!



  • Dries hands completely in 10-15 seconds
  • White Thermoset (BMC) Cover – Fiberglass re-enforced bulk molding compound
  • Surface-mounted
  • Automatic
  • GreenSpec® Approved
  • Uses 80% Less Energy
  • 95% Cost Savings vs. Paper Towels
  • Source Reduction Alternative 
  • Promotes Hygiene

SPECIFICATIONS:
Dimensions: 11 3/4" LG. X 12 11/16" HIGH X 6 11/16" DEEP
Weight: 16 LBS. (7.3 KGS.)

Construction
A. White thermoset (BMC) – Fiberglass re-enforced bulk molding compound

B. Wall plate shall be equipped with (3) 7/8" (22 mm) diameter holes, one of which shall be suitable for use with surface conduit, for ease of wiring.

C. All internal parts shall be coated according to Underwriters' Laboratories, Inc. requirements.
 
D. Entire mechanism shall be internally grounded

Mechanism
A. Motor shall be a series commutated through-flow discharge vacuum motor/blower (5/8 HP / 20,000 RPM) which provides air velocity of 16,000 LFM (linear feet per minute) at the air outlet and 14,000 LFM at the hands (4 inches [102 mm] below air outlet).

B. Heating element (900 W) is constructed of Nichrome wire and mounted inside the blower housing, thereby being vandal proof. It shall be protected by an automatic resetting thermostat, which shall open whenever air flow is cut off and shall close when flow of air is resumed. It shall produce an air temperature of up to 135°F (57°C) at a 72°F (22°C) ambient room temperature at the hands (4 inches [102 mm] below air outlet).

C. Control assembly is activated by an infrared optical sensor located next to the air outlet. The dryer shall operate as long as hands are under the air outlet. There is a 35-second lockout feature if hands are not removed.

Limited Warranty
The dryer shall be guaranteed to be free from defects for a period of three (3) years. Warranty shall include factory performed labor as well as the repair or exchange of defective parts, at manufacturer's option.

UNITS ARE AVAILABLE AS SPECIFIED IN: 110/120 Volt, 12.5 Amps, 60HZ




Browse for more products in the same category as this item:

Building Materials > Hand Dryers
Manufacturers > Excel Dryer
Energy Saving Products
Product Type > Hand Dryers


$170.00
$407.50
$437.50
$492.50
(Your shopping cart is empty)